This is an old revision of the document!
Change Log
| Release Version | Section | Description |
|---|---|---|
| 2.1 | Channels | Low set points should be before high set points (Safety and Control) |
| 2.1 | Dashboard | Need a way to create virtual buttons (On/Off, Manual/Auto) |
| 2.1 | Dashboard | Long labels do not contain themselves to the component bounds and automatically resize. Example, LED box, a long label will go on top the box and overwrite other components. |
| 2.1 | Dashboard | Long labels do not contain themselves to the component bounds and automatically resize. Example, LED box, a long label will go on top the box and overwrite other components. |
| 2.1 | Comms | Modbus registers are all read only, where are all the settings for setpoints and such? WE NEED THIS AS A STANDARD for all control panels. Everything should be configurable via modbus. |
| 2.1 | HMI | Must have a refresh button on the Dashboard and values page so it will reload the channel labels. Currently you must reboot each time to force a reload. |
| 2.1 | Dashboard | Need to be able to Insert a new HMI page between two existing pages. |
| 2.1 | Dashbaord | Sometimes clicking on the delete (trashcan) brings up the channel selector and adds a component instead of just removing the component. |
| 2.1 | Dashbaord | Need ability to set background color of Virtual Channels to show alarm state, faults,etc |
| 2.1 | Config | Fault output can be inverted, activate when faulted or activate when not faulted |
| 2.1 | Config | Start up sequence, can turn on and turn off multiple DS outputs in a single start up state |
| 2.1 | Dashboard | When defining an output there is now a single button channel selector |
| 2.1 | Dashboard | Up to 10 dashboard pages, used to be 7 |
| 2.1 | Setup | Debug page numerous bug fixes |
| 2.1 | Setup | System will power up even if terminal boards are missing |
| 2.1 | Comms | Modbus Writes available |
| 2.1 | Comms | Modbus 32 bit available |
| 2.1 | Config | Fixed several issues with loading and saving parameters |
| 2.1 | Config | Save failed error fixed |
| 2.1 | Comms | Modbus, system can be remotely locked with a modbus write, can only be unlocked with a code by someone with the unlock code |
| 2.1 | Comms | All the main button presses (stop, reset, cancel timers etc.) can be initiated with modbus writes |
| 2.1 | Comms | Can define cutsom modbus write registers. Can assign code to run when a modbus register is written to. Functions can use this then as a passed variable |