Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
documents:de4000:de4000install [2022/01/25 14:47] twebster [8.2 Default 32-bit registers] |
documents:de4000:de4000install [2022/01/25 15:10] (current) twebster [8.2 Default 32-bit registers] |
||
|---|---|---|---|
| Line 1202: | Line 1202: | ||
| | 40864:\\ 40865 | Speed Control\\ Mode | 0=Manual\\ 1=Auto | | 40864:\\ 40865 | Speed Control\\ Mode | 0=Manual\\ 1=Auto | ||
| | 40866:\\ 40867 | Manual\\ Speed | value in\\ RPM | | | 40866:\\ 40867 | Manual\\ Speed | value in\\ RPM | | ||
| + | |||
| + | Registers 41001 - 41998 are the Register Mirror Test Area(Any value written to these registers will be able to be read starting at register 30001. For example you can write a 32 bit value at 41001,41002 and read it at 30001, 30002) | ||
| + | |||
| + | Starting at register 42000:42001 The Safety Setpoint for each channel is store. First High then Low.\\ | ||
| + | Example: 42000:42001 is Terminal 1 Input 1 High Safety Setpoint and 42002:42003 is Terminal 1 Input 1 Low Safety Setpoint. | ||
| + | |||
| + | There is 100 register spacing between channels so Terminal 1 Input 2 High and Low Safety Setpoints are registers 42100:42101 and 42102:42103 | ||
| + | |||
| + | This continues for 32 channels per terminal board with 5 Terminal Boards Max | ||
| + | |||
| ===== - HAZARDOUS AREA OPERATION ===== | ===== - HAZARDOUS AREA OPERATION ===== | ||